IBM 86645RY Hardware Maintenance Manual - Page 110

Danger Electrical current from power, telephone, and communication cables is hazardous. To avoid a shock hazard: Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm. Connect all power cords to a properly wired and grounded electrical outlet. Connect to properly wired outlets any equipment that will be attached to this product. When possible, use one hand only to connect or disconnect signal cables. Never turn on any equipment when there is evidence of fire, water, or structural damage. Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device covers, unless instructed otherwise in the installation and configuration procedures. Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this product or attached devices. To Connect: 1. Turn everything OFF. 2. First, attach all cables to devices. 3. Attach signal cables to connectors. 4. Attach power cords to outlet. 5. Turn device ON. To Disconnect: 1. Turn everything OFF. 2. First, remove power cords from outlet. 3. Remove signal cables from connectors. 4. Remove all cables from devices. If you are: Installing or removing a non-hot-plug adapter, go to "Working with adapters" on page 107. Installing or removing a microprocessor, go to "Installing a microprocessor kit and VRM" on page 117. Installing or removing a memory-module kit, go to "Installing memory-module kits" on page 121. Installing or removing a drive in a non-hot-swap drive bay, go to "Installing internal drives" on page 124. 102 Netfinity Server HMM