IBM 86645RY Hardware Maintenance Manual - Page 143
Installing a hot-swap power supply, AC Power light
View all IBM 86645RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Installing a hot-swap power supply The server comes with two power supplies. You can add a third power supply. After you install a power supply, check the power-supply status indicators to verify that the power supply is operating properly. See "Power supplies" on page 96 for details. Caution Never remove the cover on a power supply or any part that has the following label attached. Hazardous voltage, current, and energy levels are present inside any component that has this label attached. There are no serviceable parts inside these components. If you suspect a problem with one of these parts, contact a service technician. Refer to the following illustration of the tower model while performing the steps in this procedure. Note You do not need to turn off the power to the server to install hot-swap power supplies. 1 Power supply 2 Filler panel 3 Cable-restraint bracket 4 Power cord connector 5 Handle on power supply (in open position) 6 AC Power light Netfinity 5600 - Type 8664 135