IBM 86645RY Hardware Maintenance Manual - Page 97
Operator information panel, Watch for the System Power
![]() |
View all IBM 86645RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
If the server is activated and a power failure occurs, the server will start automatically when power is restored. The server can also be powered on by the Netfinity Advanced System Management Processor. The server can be deactivated as follows: You can turn off the server by pressing the Power Control button on the front of the server. Pressing the Power Control button starts an orderly shutdown of the operating system, if this feature is supported by the operating system, and places the server in standby mode. Note After turning off the server, wait at least 5 seconds before pressing the Power Control button to power the server on again. You can press and hold the Power Control button for more than 4 seconds to cause an immediate shutdown of the server and place the server in standby mode. This feature can be used if the operating system hangs. You can disconnect the server power cords from the electrical outlets to shut off all power to the server. Note Wait about 15 seconds after disconnecting the power cords for the system to stop running. Watch for the System Power light on the operator information panel to stop blinking. 1 CD-ROM Drive In-Use Light: When this light is on, the CD-ROM drive is being accessed. 11 CD-ROM Manual Tray-Release Opening: Insert a straightened paper clip in the opening to release the CD-ROM tray when using the CD-ROM eject button is not successful. Operator information panel The operator information panel on the front of the server contains status lights. Netfinity 5600 - Type 8664 89
![](/manual_guide/products/ibm-86644ry-hardware-maintenance-manual-70136a6/97.png)