IBM 86645RY Hardware Maintenance Manual - Page 111
Removing the left-side cover tower model, Before you begin
![]() |
View all IBM 86645RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Removing the left-side cover (tower model) Before you begin: Read "Safety information" on page 230. Note The illustrations in this book are similar to your server; details might vary. CPU VRM PCI MBUEMS ORY A B POWER 1 2 SUPPLY 3 FAN 1 2 3 HDD NMI SMI SBNUEORSNVRICEEDUPRNODACNETSSOR TEMPERATURE 1 Cover-release latch 2 Cover To remove the left-side cover of the tower model or the top cover of the rack model: 1. If you are planning to install or remove any part other than a hot-swap hard disk drive, hot-plug adapter, hot-swap power supply, or hot-swap fan, turn off the server and all attached devices and disconnect all external cables and power cords (see "Preparing to install options" on page 100). 2. Slide the cover-release lever 1 on the front of the server to release the cover and slide the cover 2 toward the rear of the server about 25 mm (1 inch). Move the top edge of the cover out from the server; then, lift the cover off the server. Set the cover aside. Netfinity 5600 - Type 8664 103
![](/manual_guide/products/ibm-86644ry-hardware-maintenance-manual-70136a6/111.png)