IBM 86645RY Hardware Maintenance Manual - Page 133
Bays A and B, SCSI ID 4 bay
View all IBM 86645RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
1 Hot-swap bays 2 CD-ROM drive bay 3 Non-hot-swap bay B 4 Non-hot-swap bay A 5 Diskette drive bay B 6 SCSI ID 9 bay 7 SCSI ID 5 bay 8 SCSI ID 4 bay 9 SCSI ID 3 bay 1 SCSI ID 1 bay 11 SCSI ID 0 bay The server contains hardware that lets you replace a failed hard disk drive without turning off the server. Therefore, you have the advantage of continuing to operate the system while a hard disk drive is removed or installed. These drives are known as hot-swappable drives. They are also referred to as hot-swap drives. Each hot-swap drive that you plan to install must have a hot-swap-drive tray attached. The drive must have a single connector attachment (SCA) connector. Hot-swap-drive trays come with the hot-swap drives. The server comes with a preinstalled 3.5-inch, 1.44 MB diskette drive and a preinstalled IDE CD-ROM drive. Bays A and B come without a device installed. These bays are for 5.25-inch, half-high, removable-media drives, such as tape backup drives. Bays A and B can be combined into a single full-high bay. The Netfinity 5600 server supports only one diskette drive. Note The server's EMI integrity and cooling are both protected by having bays A and B covered or occupied. When you install a drive, save the filler panel from the bay, in case you later remove the drive and do not replace it with another. If you are installing a device with a 50-pin connector in one of the non-hot-swap bays (bays A-B), you need a 68-pin to 50-pin converter. To order the Netfinity 5600 - Type 8664 125