IBM 86645RY Hardware Maintenance Manual - Page 122
Installing a non-hot-plug adapter, Attention, Before you begin
View all IBM 86645RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Attention Power cannot be restored to the adapter slot if the tab is not lowered into place. d. Close the adapter retainer flap 4 . 10. Connect any needed cables to the adapter. Attention Route cables so that the flow of air from the fans is not blocked. 11. Enable the PCI slot from the operating system. (Refer to the documentation that comes with the operating system for information about enabling a hot-plug PCI slot.) Make sure that the Power light 6 for the hot-plug PCI slot is on. 12. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 141. Installing a non-hot-plug adapter This section gives the procedure for installing a non-hot-plug adapter. If you want to remove a non-hot-plug adapter, reverse the steps. Before you begin: Read "Safety information" on page 230. Read the documentation that comes with the option. Refer to the illustrations in "Installing a hot-plug PCI adapter" on page 110 while you perform the steps in this procedure. To install a non-hot-plug adapter: 1. Turn off the server and peripheral devices and disconnect all external cables and power cords (see "Preparing to install options" on page 100); then remove the cover. See "Removing the left-side cover (tower model)" on page 103 or "Removing the cover (rack model)" on page 104. 2. Determine which PCI adapter expansion slot you will use for the adapter. Note Check the instructions that come with the adapter for any requirements or restrictions. 3. Remove the expansion-slot cover 1 : a. Rotate the adapter retention latch 3 counterclockwise. b. Remove the expansion-slot cover from the server. Store it in a safe place for future use. 114 Netfinity Server HMM