IBM 86645RY Hardware Maintenance Manual - Page 128
Install the VRM, Center the VRM
![]() |
View all IBM 86645RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
To install an additional microprocessor kit: 1. Turn off the server and peripheral devices and disconnect all external cables and power cords (see "Preparing to install options" on page 100); then remove the cover (see "Removing the left-side cover (tower model)" on page 103 or "Removing the cover (rack model)" on page 104). 2. Remove the terminator card 1 from the microprocessor connector 2 . Store the terminator card in a safe place in the static-protective package that the new microprocessor is shipped in; you will need to install it again if you ever remove the microprocessor. 3. Install the microprocessor: a. Touch the static-protective package containing the new microprocessor to any unpainted metal surface on the server; then, remove the microprocessor from the package. b. Center the microprocessor 8 over the microprocessor connector 2 and carefully press the microprocessor into the connector. 4. Install the VRM 9 included in the microprocessor kit: Attention When installing or replacing a VRM, use only VRMs specified for use with the Netfinity 5600 server. Use of other VRMs might cause the server to overheat. a. Center the VRM 9 over the VRM connector 3 . Make sure that the VRM is oriented and aligned correctly. b. Press the VRM into the connector. Notes 1. To remove a microprocessor, pull upward on the microprocessor handle 7. 2. If you remove the microprocessor later, remember to install the terminator card in the appropriate microprocessor connector and to remove the VRM for that microprocessor. 5. If you have other options to install or remove, do so now; otherwise, go to "Completing the installation" on page 141. 120 Netfinity Server HMM
![](/manual_guide/products/ibm-86644ry-hardware-maintenance-manual-70136a6/128.png)