Icom ID-880H Instruction Manual - Page 10
Using the mounting bracket, Microphone connection
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
QUICK REFERENCE GUIDE D Using the mounting bracket q Drill 4 holes where the mounting bracket is to be installed. • Approx. 5.5-6 mm (1⁄4″) when using nuts; approx. 2-3 mm (1⁄8″) when using self-tapping screws. w Insert the supplied screws, nuts and washers through the mounting bracket and tighten. e Adjust the angle for your suitable position. Nut Spring washer Mounting bracket Flat washer D Microphone connection A microphone connector is available on the main unit front panel. Connect the supplied microphone connector as illus- trated below. Transceiver Microphone When using self-tapping screws 25° Mounting nut III
D
Using the mounting bracket
q
Drill 4 holes where the mounting bracket is to be installed.
•
Approx. 5.5–6 mm (
1
⁄
4
″
) when using nuts; approx. 2–3 mm (
1
⁄
8
″
)
when using self-tapping screws.
w
Insert the supplied screws, nuts and washers through the
mounting bracket and tighten.
e
Adjust the angle for your suitable position.
Nut
Spring washer
When using
self-tapping
screws
Flat washer
Mounting nut
Mounting
bracket
25°
D
Microphone connection
A microphone connector is available on the main unit front
panel. Connect the supplied microphone connector as illus-
trated below.
Transceiver
Microphone
III
QUICK REFERENCE GUIDE