Icom ID-880H Instruction Manual - Page 58
Changing a repeater list
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
4 DV MODE PROGRAMMING Gateway repeater call sign programming (GW CAL) q Push [ ](MONI) to enter the gateway repeater call sign programming. • Gateway repeater call sign programming screen is displayed. • Programmed repeater call sign is displayed, then the 1st char- acter blinks. • The 8th digit is automatically added or replaced to "G." w Rotate [DIAL] to select the desired character, number, symbol ('/' only) or space. • The selected character blinks. • Push [ ](LOW) to move the cursor right; push [ ](CS) to move the cursor left. • Push [CLR](DR) to erase the selected character, or push and hold [CLR](DR) for 1 sec. to erase all characters following the cursor. e Repeat step w until the desired repeater call sign is programmed. • Call sign can be up to 8 digits long, but 8th digit must be set to "G." Changing a repeater list This function re-programs a repeater list's contents. This is useful when already-programmed contents are mistaken or some contents are added to the list. q Enter "EDIT-L" in RPT-L menu. MENU ¶ RPT-L ¶ EDIT-L (Push [MENU ]), (rotate [DIAL], then push [ ](MONI).) • Programmed repeater name appears. SKIP indicator SKIP indicator shows the selected repeater can not be used for access repeater (RPT1) in DR mode as follow reasons. • "R1 USE" is set to "NO." • Either "FREQ" (frequency) or "DUP" (duplex direction) has not been programmed. w Push and hold [BAND] for 1 sec. to enter group selection, rotate [DIAL] to select the desired group (0-9), then push [BAND]. r Push [ ](MONI) to program the gateway repeater call sign and exit the state. 40