Icom ID-880H Instruction Manual - Page 124
Memory bank scan
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
8 SCAN OPERATION Memory bank scan IMPORTANT: To perform memory bank scan, 2 or more bank channels MUST be programmed, otherwise the scan will not start. q Select memory bank mode. ± Select the memory mode with [M/CALL]. ± Enter the bank selection state with [BAND]. ± Set the desired bank (A to Z) with [DIAL], then push [BAND]. w Set the squelch level. e Push and hold [SCAN](VFO/MHz) for 1 sec. to enter the scanning type selection. r Rotate [DIAL] to select the desired scanning type. • "ALL" for all bank scan; "B-LINK" for bank link scan or "BANK-x" for bank scan (x= A to Z; programmed bank groups are only displayed.), "DUP" (appears only when duplex operation is set) for duplex scan, "TONE" (appears only when the subaudible tone, tone squelch or DTCS squelch is set) for tone scan. t Push [SCAN](VFO/MHz) to start the scan. • Scan pauses when a signal is received. • Rotate [DIAL] to change the scanning direction. This also causes the transceiver to resume scanning. • Push [SCAN](VFO/MHz) to stop the scan. During all bank/bank link scan During bank scan [DIAL] [SCAN] All bank scan Bank link scan 106 Push and hold [SCAN] for 1 sec.,then rotate [DIAL]. Bank scan Selectable from "A" to "Z" if programmed. Duplex scan The bank-link setting can be changed in the SCAN set mode. See page 124 for details. Duplex scan function: Repeatedly scans two frequencies (transmission/reception) during duplex scan operation. Memory bank scan skips any memory channels in the selected bank that are set to "SKIP" or "PSKIP." Memory bank scan stops at the first channel when all channels in a bank are set to "SKIP" or "PSKIP."