Icom ID-880H Instruction Manual - Page 165
Reverse tone/DTCS squelch, Setting tone squelch frequency
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 165 highlights
TONE SQUELCH AND POCKET BEEP 12 D Reverse tone/DTCS squelch The reverse tone/DTCS squelch is convenient if you want to ignore a specific signal. q Set the desired operating frequency and the desired operating mode. w Set the desired CTCSS tone or DTCS code. e Push and hold [TONE](M/CALL) for 1 sec. to enter the tone selection state, then push [TONE](M/CALL) again. r Rotate [DIAL] to select the desired squelch system. Tone squelch reverse DTCS reverse t When a signal with unmatched tone or code is received, the transceiver's mute is released and the received audio sounds. The transceiver mutes the squelch when a signal with the matched tone or code is received. D Setting tone squelch frequency q Enter "C TONE" in the DUP.T menu. MENU ¶ DUP.T ¶ C TONE (p. 121) (Push [MENU ]), (rotate [DIAL], then push [ ](MONI).) [MENU ] [DIAL] [ ] w Rotate [DIAL] to select and set the desired CTCSS tone frequency, then push [ ](MONI). • Each operating band and each memory channel have independent settings. • See the table on page 148 for available tone frequencies. e Push [MENU ] to exit the DUP.T menu screen. z Enter "C TONE" in the DUP.T menu. SET B MENU ¶ DUP.T ¶ C TONE (p. 121) (Push [SET B(D-OFF)] to enter the MENU screen), (Push [Y] or [Z], then push [SET B(D-OFF)].) x Push [Y] or [Z] to select the desired tone frequency, then push [SET B(D-OFF)]. c Push [CLR A(MW)] to exit the DUP.T menu screen. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 147