Icom ID-880H Instruction Manual - Page 45
Frequency offset
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Frequency offset When communicating through a repeater, the transmit frequency is shifted from the receive frequency by an amount determined by the frequency offset. Independent offset frequencies can be set for each operating frequency band. q Select the desired mode/channel for which you wish to set the offset frequency, such as the VFO mode or a memory/ call channel. • The frequency offset is independently programmed into each mode, band or channel. w Enter "OFFSET" in the DUP.T menu. MENU ¶ DUP.T ¶ OFFSET (p. 121) (Push [MENU ]), (Rotate [DIAL], then push [ ](MONI).) [MENU ] [DIAL] [ ] e Rotate [DIAL] to set the desired frequency offset, then push [ ](MONI). • Push [VFO/MHz] to turn 10 MHz or 1 MHz tuning ON or OFF r Push [MENU ] again to exit the DUP.T menu. REPEATER OPERATION 3 z Push [BAND] to select the desired band. SET B • Enter the desired frequency via the keypad if necessary. 3 x Select the desired mode/channel for which you wish to set the offset frequency, such as the VFO mode or a memory/call channel. • The frequency offset can be independently pro- grammed into each mode, band or channel. c Enter "OFFSET" in the DUP.T menu. MENU ¶ DUP.T ¶ OFFSET (p. 121) (Push [SET B(D-OFF)] to enter the MENU screen), (Push [Y] or [Z], then push [SET B(D-OFF)].) v Push [Y] or [Z] to set the desired offset. • Direct frequency entry from the keypad is not possible. b Push [CLR A(MW)] to exit the set mode. NOTE: The frequency offset can be set in a memory/call channel temporarily. However, the set frequency is cleared once another memory channel or the VFO mode is selected. To store the frequency offset permanently, overwrite the channel information. 27