Icom ID-880H Instruction Manual - Page 12
Remote installation - head
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
QUICK REFERENCE GUIDE D Remote installation The supplied remote controller bracket is used for remote installation. These screws are not supplied. • Attach the remote controller bracket onto a flat surface using with 4 self-tapping screws (2.6 mm(d)), or dou- ble-sticky tape, etc., as at left, then attach remote con- troller to the bracket. Remote controller bracket When installing into your vehicle q Remove two screws and magnets from the remote controller. Magnet Remote controller FH: Flat head FH M2.6 × 6 mm CAUTION: NEVER use any other than the supplied screws (FH M2.6 × 6 mm) if re-attaching the magnets to the remote controller. Otherwise the transceiver's internal board may be damaged. w Attach the removed magnets to the remote controller bracket. Remote controller bracket e Attach the supplied remote controller bracket as below. Remote controller FH: Flat head FH M2.6 × 8 mm Remote controller bracket (with magnets) CAUTION: NEVER use any other than the supplied screws (FH M2.6 × 8 mm) for attaching the remote controller bracket. Otherwise the transceiver's internal board may be damaged. r Attach the remote controller on to the optional MB-120 as below. Remote controller bracket Adjust the viewing angle for maximum visibility of the function display. Optional MB-120 Magnet V