Icom ID-880H Instruction Manual - Page 121
Scan edges programming
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
SCAN OPERATION 8 Scan edges programming Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 0A/0B to 24A/24B, in memory channels. q Push [VFO/MHz] to select the VFO mode. w Set the desired frequency: ± Select the desired band with [BAND]. ± Set the desired frequency with [DIAL]. ± Program different frequencies in "11A" and "11B" re- spectively. ± Set other data (e.g. frequency offset, duplex direction, tone squelch, etc.), if desired. e Push [S.MW](MW) to enter the select memory write mode. • " " indication and memory channel number blink. r Rotate [DIAL] to select the desired programmed scan edge channel from 0A to 24A. t Push and hold [MW](S.MW) for 1 sec. • 3 beeps sound. • The other scan edge channel "B," 0B to 24B, is automatically selected when continuing to push [MW](S.MW) after program- ming. y To program a frequency for the other pair of scan edges, 0B to 24B, repeat steps w and t. • If the same frequency is programmed into a pair of scan edges, 8 programmed scan will not function. [EXAMPLE]: Programming 145.300 MHz into scan edges 4A. Push [S.MW]. Rotate [DIAL] to select scan edge channel 4A. [DIAL] [S.MW ] VFO mode Enter select memory write mode. Push and hold [MW] for 1 sec. to program Channel 4A Return to the VFO mode. 103