Icom ID-880H Instruction Manual - Page 117
Erasing/transferring bank contents
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
7 MEMORY CHANNEL OPERATION Erasing/transferring bank contents 1 The bank contents of programmed memory channels can be cleared or reassigned to another memory bank. INFORMATION: Even if the memory bank contents are cleared, the memory channel contents still remain programmed. e Push [ ](MONI) to select "BANK" setting, then push [ ] 2 (MONI) again. 3 4 5 q Select the desired bank contents to be transferred or erased from the bank. (p. 93) ± Push [M/CALL] several times to select the memory mode. ± Push [BAND], then rotate [DIAL] to select the desired memory bank group, then push [BAND] again. ± Rotate [DIAL] to select the bank channel. • Bank initial and bank channel stops blinking. [DIAL] [BAND] r Push [ ](LOW) to select the bank channels selection, or 6 push [ ](CS) to select the bank group selection to be trans- ferred. 7 t Rotate [DIAL] to select the desired bank group or channel. 8 • Push [CLR](DR) or select "- - - -" indication when erasing the contents from the bank. 9 To transfer the bank contents 10 to channel 11 in Bank B. 11 12 [S.MW ] [M/CALL] w Push [S.MW] to enter the select memory write mode. • Displays the original memory channel number automatically, and then "X" indicator and the memory channel number blink. • Do not hold [S.MW](MW) for more than 1 sec., otherwise the memory contents will be copied to the VFO. 13 Bank channel is displayed. 14 To erase. 15 [DIAL] [] [][ ] 16 [S.MW ] [CLR] 17 "- - - -" is displayed. y After editing, push [ ](MONI) to select "BANK" setting. 18 u Push [MW](S.MW) for 1 sec. to erase/transfer the bank 19 contents. 99