Icom ID-880H Instruction Manual - Page 49
Call sign programming
View all Icom ID-880H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
DV MODE PROGRAMMING 4 Call sign programming Four types of current call sign memory are available; "MY" (my call sign=your own call sign) "UR" (your call sign=other station call sign) "RPT1" (access repeater call sign) and "RPT2" (linked repeater call sign). Each call sign can be programmed with up to 8 characters. In addition, "MY" can store up to 6 call signs, and "UR" can store up to 60 call signs in the call sign memory. Up to 300 repeater call signs can be stored in the repeater list. D Your own call sign programming Your own call sign must be programmed for both digital voice and low-speed data communications (including GPS transmission). q Enter "MY" in call sign screen. MENU ¶ CALL-S ¶ MY (Push [MENU ]), (rotate [DIAL], then push [ ](MONI).) • MY call sign screen is displayed. w Rotate [DIAL] to select the desired call sign memory, "MY1" to "MY6." 1 e Push [ ](LOW) to enter call sign programming mode. 2 • The 1st digit blinks. 3 4 5 r Rotate [DIAL] to select the desired character or code. 6 • Push [ ](LOW) to move the cursor right; push [ ](CS) to move the cursor left. 7 8 9 t Repeat the step r to enter your own call sign. 10 • Call sign can be up to 8 digits long. 11 • If an unwanted character is entered, push [ ](LOW) or [ ](CS) to select the character, then push [CLR](DR) to erase the se- 12 lected character, or push and hold [CLR](DR) for 1 sec. to erase 13 all characters following the cursor. • To program a note (up to 4 characters, for operating radio type, 14 area, etc.), go to step y, otherwise go to step i. y Push [ ](LOW) several times to set the cursor beside "/" 15 indication. 16 17 18 19 31