Sharp MX-M232D Operation Guide - Page 49
Interrupting A Copy Run
View all Sharp MX-M232D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
INTERRUPTING A COPY RUN (Interrupt copying) A copy run can be temporarily interrupted to allow another copy job to be performed. (Interrupt copying) When the other job is finished, the copy run will resume using the original copy settings. • Interrupt copying is not possible when the document glass is being used for a copy job and "NO SORT" is selected. • When 2 in 1 or 4 in 1 is selected, interrupt copying is not possible. • Sort copying, 2 in 1, and 4 in 1 and automatic two-sided copying cannot be used for an interrupt copy job. Configuring settings in the system settings, use as a scanner, and fax transmission are also not possible. 1 Press the [INTERRUPT] key ( ). If the [INTERRUPT] key ( ) is INTERRUPT pressed, copying will stop and the settings will temporarily return to the default settings after the copy in progress has been completed. The INTERRUPT indicator will blink until the current copy run stops. Note If you press the [INTERRUPT] key ( ) when auditing mode is enabled, "Enter your account number." will appear in the display. Enter your account number using the numeric keys. The pages copied during interrupt copying will be added to the count of the entered account number. (p.114) 2 When the copy run stops, remove the previous original(s) and place the original(s) of the interrupt copy job. 3 Select copy settings as needed. 4 Set the number of copies and then press the [START] key ( ). MNO WXYZ @.-_ AD-END Note (C) (B) (A) The interrupt copies will be offset from the previous copies. (Offset function) The offset function can be disabled in the system settings. (p.117) (A): Copies made before the interrupt copy job (B): Interrupt copies (C): Copies made after the interrupt copy job * This function is not available in some countries and regions. 3 5 When the copy job is finished, press the [INTERRUPT] key ( ) to end interrupt mode and remove the original(s). The INTERRUPT indicator will turn off, indicating that the interrupt function is no longer operating. The copy settings will automatically revert to the settings selected for the copy run before the run was interrupted. 6 Replace the previous original(s) and press the [START] key ( ). The interrupted copy run will resume. Downloaded from www.Manualslib.com manuals search engine 48