Sony STR-DN1040 Operating Instructions (Large File - 14.3 MB) - Page 125
BRAVIA Sync Control, for HDMI, Recording equipment Blu-ray Disc
View all Sony STR-DN1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Additional Information Cannot make the Bluetooth connection. • The Bluetooth device you attempted to connect does not support the A2DP profile, and cannot be connected with the receiver. • Press BLUETOOTH on the receiver to connect to the last connected Bluetooth device. • Turn on the Bluetooth function of the Bluetooth device. • Establish a connection from the Bluetooth device. • The pairing registration information has been erased. Perform the pairing operation again (page 78). • While connected to a Bluetooth device, this receiver cannot be detected and a connection cannot be established from another Bluetooth device. • Erase the pairing registration information of a Bluetooth device (page 80) and perform the pairing operation again. The sound skips or fluctuates, or the connection is lost. • The receiver and the Bluetooth device are too far apart. • If there are obstacles between the receiver and your Bluetooth device, remove or avoid the obstacles. • If there is equipment that generates electromagnetic radiation, such as a wireless LAN, other Bluetooth device, or a microwave oven nearby, move them away. The sound of your Bluetooth device cannot be heard on this receiver. • Turn up the volume on your Bluetooth device first, and then adjust the volume using 2 + (or MASTER VOLUME on the receiver). Severe hum or noise. • If there are obstacles between the receiver and your Bluetooth device, remove or avoid the obstacles. • If there is equipment that generates electromagnetic radiation, such as a wireless LAN, other Bluetooth device, or a microwave oven nearby, move them away. • Turn down the volume of the connected Bluetooth device. "BRAVIA" Sync (Control for HDMI) The Control for HDMI function does not work. • Check the HDMI connection (page 31, 32). • Make sure "Control for HDMI" is set to "On" in HDMI Settings menu (page 99). • Make sure the connected equipment is compatible with the Control for HDMI function. • Check the Control for HDMI settings on the connected equipment. Refer to the operating instructions of the connected equipment. • If you unplug the HDMI cable or change the connection, repeat the procedures of "Preparing for the "BRAVIA" Sync" (page 82). • When "Control for HDMI" is set to "Off", the "BRAVIA" Sync does not work properly, even if the equipment is connected to the HDMI IN jack. • The types and the number of equipment which can be controlled by the "BRAVIA" Sync feature are restricted in the HDMI CEC standard as follows. - Recording equipment (Blu-ray Disc recorder, DVD recorder, etc.): up to 3 equipment 125US