Sony STR-DN1040 Operating Instructions (Large File - 14.3 MB) - Page 22
Function for conversion of video signals, Notes on converting video, signals - hdmi 2 0
View all Sony STR-DN1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Function for conversion of video signals The receiver is equipped with a function for converting video signals. Video signals and component video signals can be output as HDMI video signals. As the default setting, video signals input from the connected equipment are output as shown in the table with solid arrows. INPUT jack HDMI IN OUTPUT jack HDMI OUT COMPONENT VIDEO IN COMPONENT VIDEO MONITOR OUT VIDEO IN MONITOR OUT : Same type of signal as that of the input signal is output. : Video signals are upconverted and output (up to 4K). Notes on converting video signals • When video signals from a VCR, etc., are upconverted on this receiver and then viewed on your TV, depending on the status of the video signal output, the image on the TV screen may appear distorted horizontally or no image can be seen. • If you are using an image improvement circuitry with your VCR, it may impact the video signal conversion. It is recommended to turn off this function on your VCR. • Converted HDMI image output does not support "x.v.Color (x.v.Colour)", Deep Color (Deep Colour), and 3D. • HDMI video signals cannot be converted to component video signals and video signals. • 1080p component video signals cannot be upconverted. 22US