Sony STR-DN1040 Operating Instructions (Large File - 14.3 MB) - Page 37
Preparing the Receiver, Setting the voltage selector, Connecting the AC power cord (mains lead)
View all Sony STR-DN1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Preparing the Receiver Preparing the Receiver Turning on the receiver Setting the voltage ?/1 selector If your receiver has a voltage selector on the rear panel, check that the voltage selector is set to the local power supply voltage. If not, use a screwdriver to set the selector to the correct position before connecting the AC power cord (mains lead) to a wall outlet. Depending on the area, the VOLTAGE SELECTOR may differ. Connecting the AC power cord (mains lead) Connect the AC power cord (mains lead) to a wall outlet. AC power cord (mains lead) Press ?/1 to turn on the receiver. You can also turn on the receiver using ?/1 button on the remote control. When you turn off the receiver, press ?/1 again. "STANDBY" flashes on the display panel. Do not disconnect the AC power cord (mains lead) while "STANDBY" is flashing. This may cause a malfunction. Setting up the receiver using the Easy Setup You can set the basic settings of the receiver easily by operating the receiver in accordance with the instructions on the TV screen. Switch the input of the TV to the input which the receiver is connected. When you turn on the receiver for the first time or after the receiver is initialized, the Easy Setup screen appears on the TV screen. Proceed to set up the receiver in accordance with the instructions on the Easy Setup screen. You can set up the following functions using the Easy Setup. - Speaker Settings - Network Settings To the wall outlet 37US