TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 290

Configuring GVRP GVRP Configuration Step 8 Step 9 Step 10 show gvrp interface [ fastEthernet port | gigabitEthernet port | port-channel port-channelid ] Verify the GVRP configuration of the specified port or LAG. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. Note: • The member port of an LAG follows the configuration of the LAG but not its own. The configurations of the port can take effect only after it leaves the LAG. • When setting the timer values, make sure the values are within the required range. The value for LeaveAll should be greater than or equal to ten times the Leave value. The value for Leave should be greater than or equal to two times the Join value. The following example shows how to enable GVRP globally and on trunk port 1/0/1, configure the GVRP registration mode as fixed and keep the values of timers as default: Switch#configure Switch(config)#gvrp Switch(config)#interface gigabitEthernet 1/0/1 Switch(config-if)#gvrp Switch(config-if)#gvrp registration fixed Switch(config-if)#show gvrp global GVRP Global Status Enabled Switch(config-if)# show gvrp interface gigabitEthernet 1/0/1 Port Status Reg-Mode LeaveAll JoinIn Leave LAG ---- Gi1/0/1 Enabled Fixed 1000 20 60 N/A Switch(config-if)#end Switch#copy running-config startup-config Configuration Guide 260