TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 953

Configuring SNMP & RMON SNMP Configurations Read View Write View Notify View Choose a view to allow parameters to be viewed but not modified by the NMS. The view is necessary for any group. By default, the view is viewDefault. To modify parameters of a view, you need to add it to Write View. Choose a view to allow parameters to be modified but not viewed by the NMS. The default is none. The view in Write View should also be added to Read View. Choose a view to allow it to send notifications to the NMS. 2.1.4 Creating SNMP Users Choose the menu SNMP > SNMP Config > SNMP User to load the following page. Figure 2-4 SNMP User Follow these steps to create an SNMP user: 1) Specify the user name, user type and the group which the user belongs to. Set the security model according to the related parameters of the specified group. If you choose SNMPv3, you need to configure the security level. User Name Set the SNMP user name. You may use 1 to 16 characters. For different entries, user names cannot be the same. User Type Choose a user type to indicate the location of the user. The default is Local User. Local User: The user resides on the local engine, which is the SNMP Agent of the switch. Remote User: The user resides on a remote engine, which is the SNMP Agent of some other device. For this user type, you need to set the remote engine ID first. Group Name Choose the group that the user belongs to. Users with the same Group Name, Security Model and Security Level will be in the same group. Configuration Guide 923