TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 734

Configuring ACL ACL Configuration Switch(config)#end Switch#copy running-config startup-config 2.2.4 ACL Binding and Policy Binding You can select ACL binding or Policy binding according to your needs. An ACL Rule and policy takes effect only after they are bound to a port or VLAN.  Policy Binding You can bind the policy to a port or a VLAN, then the received packets will be matched and operated based on the policy. Step 1 configure Enter global configuration mode Step 2 interface { fastEthernet port | range fastEthernet port-list | gigabitEthernet port | range gigabitEthernet port-list | ten-gigabitEthernet port | range ten-gigabitEthernet port-list } access-list bind policy-name (Optional) Enter layer 2 interface configuration mode and bind the policy to the port. port: The port to which the policy will bind. policy-name: The name of the policy. interface vlan vlan-id access-list bind policy-name (Optional) Enter layer 3 interface configuration mode and bind the policy to the VLAN. Note: Packet Content ACLs cannot be bound to any VLANs. vlan-id: The VLAN to which the policy will bind. policy-name: The name of the policy. Step 3 end Return to privileged EXEC mode. Step 4 copy running-config startup-config Save the settings in the configuration file. The following example shows how to bind policy 1 to port 2 and policy 2 to VLAN 2: Switch#configure Switch(config)#interface gigabitEthernet 1/0/2 Switch(config-if)#access-list bind 1 Switch(config-if)#exit Configuration Guide 704