TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 94

Managing System Access Security Configurations Max Connect Specify the maximum number of the connections to the SSH server. New connection will not be established when the number of the connections reaches the maximum number you set. 2) In the Encryption Algorithm section, select the encryption algorithm you want the switch to support and click Apply. 3) In Data Integrity Algorithm section, select the integrity algorithm you want the switch to support and click Apply. 4) In Key Download section, select key type from the drop-down list and select the desired key file to down. Key Type Select the key type. The algorithm of the corresponding type is used for both key generation and authentication. Key File Select the desired public key to download to the switch. The key length of the downloaded file ranges of 512 to 3072 bits. Note: It will take a long time to download the key file. Please wait without any operation. 5.1.5 Enabling the Telnet Function Choose the menu System > Access Security > Telnet Config to load the following page. Figure 5-4 Configuring the Telnet Function In the Global Config section, select Enable and click Apply. Telnet Select Enable to make the Telnet function effective. Telnet function is based on the Telnet protocol subjected to TCP/IP protocol. It allows users to log on to the switch remotely. 5.2 Using the CLI 5.2.1 Configuring the Access Control Follow these steps to configure the access control: Step 1 configure Enter global configuration mode. Configuration Guide 64