TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 576

Configuring DHCP DHCP Server Configuration Step 7 Step 8 Step 9 Step 10 Step 11 Step 12 ip dhcp server exclude-address start-ip-address end-ip-address Specify the start IP address and end IP address of the excluded IP address range. If the start IP address and the end IP address are the same, the server excludes only one IP address. When configuring DHCP Server, you need to reserve certain IP addresses for each subnet, such as default gateway address, broadcast address and DNS server address. start-ip-address/end-ip-address: Specify the start IP address and end IP address. show ip dhcp server status Verify the DHCP status, including whether it is enabled and the configuration of ping packet number and ping packet timeout. show ip dhcp server extend-option Verify the configuration of the extend options. show ip dhcp server excluded-address Verify the configuration of the excluded IP address. end Return to Privileged EXEC Mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to enable DHCP Server globally on Switch, configure the number of ping packets as 2 and configure the ping timeout period as 200 ms: Switch#configure Switch(config)#service dhcp server Switch(config)#ip dhcp server ping packets 2 Switch(config)#ip dhcp server ping timeout 200 Switch(config)#show ip dhcp server status DHCP server is enable. Ping packet number: 2. Ping packet timeout: 200 milliseconds. Switch(config)#end Switch#copy running-config startup-config Configuration Guide 546