TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 964

Configuring SNMP & RMON Notification Configurations IP Mode Choose an IP mode for the host, which should be coordinated with the IP Address. 2) Specify the user name or community name used by the NMS, and configure the security model and security level based on the settings of the user or community. User Name Specify the user name or community name used by the NMS. Security Model Choose the corresponding SNMP version for the NMS. The version should be consistent with settings of the user or community. v1: The NMS uses SNMPv1. v2: The NMS uses SNMPv2c. v3: The NMS uses SNMPv3. Security Level Choose the security level for the NMS that uses SNMPv3. The setting should be consistent with that of the specified user or community. noAuthNoPriv: No authentication mode or privacy mode is applied to check or encrypt packets. authNoPriv: An authentication mode is applied to check packets, but no privacy mode to encrypt packets. authPriv: An authentication mode and a privacy mode are applied to check and encrypt packets. 3) Choose a notification type based on the SNMP version. If you choose the Inform type, you need to set retry times and timeout interval. Type Choose a notification type for the NMS that uses SNMPv2c or SNMPv3; the default type is Trap. Trap: Set the switch to send Trap messages to the NMS. When the NMS receives a trap message, it will not send a response to the switch. Thus the switch cannot determine whether the trap is received or not, and the trap that is not received will not be resent. Inform: Set the switch to send Inform messages to the NMS. When the NMS receives an Inform message, it sends a response to the switch. If the switch does not receive a response within the Timeout interval, it will resend the Inform message. Therefore, Informs are more reliable than Traps. Retry Set the retry times for Informs; the default is 3. The switch will resend the Inform message if it does not receive response from the NMS within the timeout interval. It will stop sending Inform messages when the retry time reaches the limit. Timeout 4) Click Create. Set the length of time that the switch waits for a response from the NMS after sending an inform message; the default is 100 seconds. Set the length of time that the switch waits for a response from the NMS after sending an inform message; the default is 100 seconds. Configuration Guide 934