TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 875

Configuring LLDP LLDP Configurations Step 3 Step 4 Step 5 Step 6 Step 7 lldp hold-multiplier (Optional) Specify the amount of time the neighbor device should hold the received information before discarding it. The default is 4. TTL (Time to Live) = Hold Multiplier * Transmit Interval. lldp timer { tx-interval tx-interval | tx-delay tx-delay | reinit-delay reinit-delay | notifyinterval notify-interval | fast-count fast-count } (Optional) Configure the timers for LLDP packet forwarding. tx-interval: Enter the interval between successive LLDP packets that are periodically sent from the local device to its neighbors. tx-delay: Specify the amount of time that the local device waits before sending another LLDP packet to its neighbors. The default is 2 seconds. reinit-delay: Specify the amount of time that the local device waits before sending another LLDP packet to its neighbors. The default is 2 seconds. notify-interval: Enter the interval between successive Trap messages that are periodically sent from the local device to the NMS. The default is 5 seconds. fast-count: Specify the number of packets that the local port sends when its Admin Status changes. The default is 3. show lldp Display the LLDP information. end Return to Privileged EXEC Mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to configure the following parameters, lldp timer=4, tx-interval=30 seconds, tx-delay=2 seconds, reinit-delay=3 seconds, notify-iInterval=5 seconds, fast-count=3. Switch#configure Switch(config)#lldp Switch(config)#lldp hold-multiplier 4 Switch(config)#lldp timer tx-interval 30 tx-delay 2 reinit-delay 3 notify-interval 5 fastcount 3 Switch(config)#show lldp LLDP Status: Enabled Tx Interval: 30 seconds Configuration Guide 845