TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 928

Configuring Maintenance System Log Configurations Channel Level Status Sync-Periodic ------- Buffer 5 enable Immediately Flash 2 enable 10 hour(s) Monitor 5 enable Immediately Switch(config)#end Switch#copy running-config startup-config 4.2.2 Configuring the Remote Log Remote Log enables the switch to send system logs to a host. To display the logs, the host should run a log server that complies with the syslog standard. Follow these steps to set the remote log: Step 1 Step 2 Step 3 Step 4 Step 5 configure Enter global configuration mode. logging host index idx host-ip level Configure the log host which receives the system logs from other devices. You can remotely monitor the settings and operation status of other devices through the log host. idx: Enter the index of the log host. The switch supports 4 log hosts at most. host-ip: Specify the IP address for the log host. level: Enter the severity level of the log information that should be sent to each log host. The range is 0 to 7, and the smaller value has the higher priority. Only the log with the same or smaller severity level value will be sent to the corresponding log host. The default is 6, indicating that the log information of levels 0 to 6 will be sent to the log host. show logging loghost [ index ] View the configuration information of the log host. index: Enter the index of the log host to view the corresponding configuration information. If no value is specified, information of all log hosts will be displayed. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to set the remote log on the switch. Enable log host 2, set its IP address as 192.168.0.148, and allow logs of levels 0 to 5 to be sent to the host: Switch#configure Switch(config)# logging host index 2 192.168.0.148 5 Configuration Guide 898