TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 919

Configuring Maintenance SFlow Configuration Agent Address Enter the management IP address of the switch to monitor traffic on the switch port. sFlow Version The sFlow version is V5. 2) In the Collector Config section, select a collector to configure relevant parameters, and click Apply. Collector ID Select a collector for configuration. The switch supports 4 collectors at most. Description Give a collector description for identification with 16 characters at most. Collector IP Enter the IP address of the host that runs the sFlow collector. Collector Port Specify the UDP port number for the sFlow collector. The default is port 6343. Max Datagram Specify the maximum number of data bytes that can be sent in a single sample datagram. The values are from 300 to 1400 bytes and the default is 300 bytes. Timeout (s) Specify the aging time after which the sFlow collector will become invalid. The values are from 0 to 2000000 seconds; the default is 0, which means the collector is always valid. Lifetime (s) Displays the remaining time of the collector. Lifetime counts down from Timeout. 3.1.2 Configuring the SFlow Sampler Choose the menu Maintenance > sFlow> sFlow Sampler to load the following page. Figure 3-2 Configuring the SFlow Sampler Configuration Guide 889