TP-Link T2600G-18TSTL-SG3216 T2600G-18TSUN V1 Configuration Guide - Page 96

Managing System Access Security Configurations User authentication mode: IP based Index IP Address Access Interface 1 192.168.0.0/24 SNMP Telnet HTTP HTTPS Switch(config)#end Switch#copy running-config startup-config 5.2.2 Configuring the HTTP Function Follow these steps to configure the HTTP function: Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 configure Enter global configuration mode. ip http server Enable the HTTP function. By default, it is enabled. ip http session timeout minutes Specify the Session Timeout time. The system will log out automatically if users do nothing within the Session Timeout time. minutes: Specify the timeout time, which ranges from 5 to 30 minutes. The default value is 10. ip http max-users admin-num guest-num Specify the maximum number of users that are allowed to connect to the HTTP server. The total number of users should be no more than 16. For T2600-18TS, the number of Operator, Power User and User can be set respectively. admin-num: Enter the maximum number of users whose access level is Admin. The valid values are from 1 to 16. guest-num: Enter the maximum number of users whose access level is Operator, Power User or User. The valid values are from 0 to 15. show ip http configuration Verify the configuration information of the HTTP server, including status, session timeout, access-control, max-user number and the idle-timeout, etc. end Return to privileged EXEC mode. copy running-config startup-config Save the settings in the configuration file. The following example shows how to set the session timeout as 9, set the maximum admin number as 6, and set the maximum guest number as 5. Switch#configure Configuration Guide 66