Uniden BCD996P2 English Manual - Page 85
Search For°°° Menu
View all Uniden BCD996P2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Set Delay Time this setting determines how long the scanner waits after a transmission ends before resuming Quick Search and Close Call Search operations. A negative delay will force a resume after that number of seconds. The default setting is 2 seconds. 1. Scroll to 'Set Delay Time' and press E/ . 2. Scroll to the desired delay time (-10, -5, -2, 0, 1, 2, 5, 10, or 30 secs.) and press E/ to save and exit. Set Attenuator this setting controls the attenuator for Quick Search, Close Call, and Band Scope operations. Turn on this setting if you are near other strong signal sources to attenuate about 20dB. Attenuation sometimes helps to reduce interference and desensitization that strong signals create. The default setting is Off. 1. Scroll to 'Set Attenuator' and press E/ . 2. Scroll to On or Off and press E/ to save and exit. Note: You can also toggle attenuation for search/close call mode by pressing then 7(ATT). Set Record this setting enables the REC jack for Quick Search and Close Call modes. The default setting is Off. 1. Scroll to 'Set Record' and press E/ . 2. Scroll to On or Off and press E/ to save and exit. Set Audio AGC allows you to turn the AGC feature on or off for Quick Search and Close Call modes. See also Adjust Audio AGC. 1. Scroll to 'Set Audio AGC' and press E/ . 2. Scroll to 'Analog' and press E/ to toggle on or off. 3. Scroll to 'Digital' and press E/ to toggle on or off. 4. Press MENU to return. P25 Waiting Time basically gives the scanner time to determine if frequencies have digital or analog transmissions for Quick Search, Close Call, and Band Scope operations. During this time, the scanner will evaluate the received signal and, if it detects P25 data, will open squelch immediately. If P25 is not detected before the delay expires, the scanner will open squelch at the end of this delay. This is to prevent "false decode" problems (digital noise at the beginning of transmissions). The default setting is 400 ms. 1. Scroll to 'P25 Wait Time' and press E/ . 2. Set the Wait Time from 0 to 1000 ms and press E/ . Note: Any analog transmissions will lose the first part of the transmission, up to the wait time you set here. SEARCH FOR... MENU Important! There are many options and setting in Search/Close Call Options that affect and compliment the settings for searching. Please review those first. Edit Service Search Set Search Key Storing a Displayed Frequency Service Search Search and Store Reviewing Locked out Frequencies 81