Uniden BCD996P2 English Manual - Page 95
Managing Close Call Hits, In Close Call Hold Mode
View all Uniden BCD996P2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
MANAGING CLOSE CALL HITS In Close Call Only Mode When the scanner detects a Close Call signal, 'Close Call' appears for the length of time set in Close Call Pause (or until the signal is lost if longer). The band number will blink under the band that the hit was found in. The frequency is displayed for the (+) delay time set in Search/Close Call Options (even if it's gone). To hold on a CC hit press HOLD. Press HOLD again to resume. See Close Call Hold Mode. To store a frequency press E/ then see Storing a Displayed Frequency. To cancel a CC hit turn the scroll control. To toggle CC bands off or on press the number key for each band. To toggle the lock out status of a frequency press L/O. To view the last CC hit press HOLD. Press HOLD again to resume. To toggle the attenuation on or off (for all bands) press then 7(ATT). To toggle the modulation (for all bands) press then 9(MOD). To exit CC only press SQ. While Scanning or Searching with Close Call Override set to On, when the scanner detects a Close Call signal, the scanner overrides the current audio and goes to the Close Call hit. 'Close Call' appears for the length of time set in Close Call Pause (or until the signal is lost if longer). If you do not press 'HOLD', the scanner will return to scanning after 'pause' times out. The signal is audible and displayed for the (+) delay time set in Search/Close Call Options (even if it's gone). Quickly press HOLD to stay on the frequency. Press HOLD again to resume. While Scanning or Searching with Close Call Override set to Off, when the scanner detects a Close Call signal, the scanner does not override the current audio. 'CC Found!' and 'Press Func Key' appear for the length of time set in Close Call Pause. If you do not press 'Func', the scanner will return to scanning after 'pause' times out. Press to listen to and display the frequency for the (+) delay time set in Search/Close Call Options (only if it's still there). Quickly press HOLD to stay on the frequency. Press HOLD again to resume. IN CLOSE CALL HOLD MODE To store a frequency press E/ then see Storing a Displayed Frequency. To toggle the lock out status of a frequency press L/O. To start a 'Quick Search' at the current frequency turn the scroll control then press HOLD. To turn Intermediate Frequency Exchange on or off press then 4(IFX). To check for a repeater frequency press then press and hold 8(REV). 91