2010 Jeep Liberty Owner's Manual - Page 154

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 153 light bulb. If an indicator fails to light when the lever is NOTE: If the multifunction lever is held in the flash-tomoved, it would suggest that the indicator bulb is pass position for more than 15 seconds, the high beams will shut off. If this occurs, wait 30 seconds before defective. activating the flash-to-pass function again. Lane Change Assist Tap the lever up or down once, without moving beyond Instrument Panel Dimmer the detent, and the turn signal (right or left) will flash Rotate the center portion of the lever to the extreme bottom position to fully dim the instrument panel lights three times then automatically turn off. and prevent the interior lights from illuminating when a High/Low Beam Switch door is opened. Push the multifunction lever away from you to switch the headlights to high beam. Pull the multifunction lever Rotate the center portion of the lever up to increase the toward you, to switch the headlights back to low beam. brightness of the instrument panel lights when the parking lights or headlights are on. Flash-To-Pass You can signal another vehicle with your headlights by Rotate the center portion of the lever upward to the next lightly pulling the multifunction lever toward you. This detent position to brighten the odometer and radio when will turn on the high beam headlights until the lever is the parking lights or headlights are on. released. 3