2010 Jeep Liberty Owner's Manual - Page 310

STARTING AND OPERATING 309 WARNING! It is dangerous to move the shift lever out of PARK or NEUTRAL if the engine speed is higher than idle speed. If your foot is not firmly on the brake pedal, the vehicle could accelerate quickly forward or in reverse. You could lose control of the vehicle and hit someone or something. Only shift into gear when the engine is idling normally and when your foot is firmly on the brake pedal. Brake/Transmission Shift Interlock System This vehicle is equipped with a Brake Transmission Shift Interlock System (BTSI) that holds the shift lever in the PARK position when the ignition switch is in the LOCK position. To move the shift lever out of the PARK position, the ignition switch must be turned to the ON or START position (engine running or not) and the brake pedal must be pressed. Brake/Transmission Interlock Manual Override Your vehicle may be equipped with a shift lock manual override. The manual override may be used in the event Key Ignition Park Interlock that the shift lever should fail to move from PARK with This vehicle is equipped with a Key Ignition Park Interthe key in the ON position and the brake pedal pressed. lock which requires the shift lever to be placed in PARK To operate the shift lock manual override, perform the prior to rotating the key to the LOCK position. The key following steps: can only be removed from the ignition when the ignition is in the LOCK position and once removed the shift lever 1. Turn the key to the ON position but do not start the engine. is locked in PARK. 2. Firmly set the parking brake. 5