2010 Jeep Liberty Owner's Manual - Page 177

176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE WARNING! (Continued) • Vehicle exhaust contains carbon monoxide, a dangerous gas. Do not run your vehicle in the garage while training the transceiver. Exhaust gas can cause serious injury or death. Programming HomeLink Your vehicle should be parked outside of the garage when programming. 1. Turn the ignition switch to the ON/RUN position. 2. Hold the battery side of the handheld transmitter away from the HomeLink button you wish to program. Place the handheld transmitter 1-3 in (3-8 cm) away from the HomeLink button you wish to program while keeping the indicator light in view. Before You Begin If you have not trained any of the HomeLink buttons, 3. Simultaneously press and hold both the chosen erase all channels before you begin training. HomeLink button and the handheld transmitter button To do this, press and hold the two outside buttons for until the HomeLink indicator changes from a slow to a 20 seconds until the red indicator flashes. rapidly blinking light, then release both the HomeLink It is recommended that a new battery be placed in the and handheld transmitter buttons. handheld transmitter of the device that is being copied to Watch for the HomeLink indicator to change flash rates. HomeLink for more efficient training and accurate When it changes, it is programmed. It may take up to transmission of the radio-frequency signal. 30 seconds or longer in rare cases. The garage door may open and close while you train.