2010 Jeep Liberty Owner's Manual - Page 167

166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE ParkSense will remember the last system state (enabled ParkSense Warning Display or disabled) from the last ignition cycle when the ignition The ParkSense Warning screen will only be displayed if Sound and Display is selected from the Customeris changed to the RUN/ON position. Programmable Features section of the Electronic Vehicle ParkSense can be active only when the shift lever is in Information Center (EVIC). Refer to "Electronic Vehicle REVERSE. If ParkSense is enabled at this shift lever Information Center (EVIC)/Personal Settings (Customerposition, the system will be active until the vehicle speed Programmable Features)" in "Understanding Your Inis increased to approximately 11 mph (18 km/h) or strument Panel" for further information. above. The system will be active again if the vehicle speed is decreased to speeds less than approximately The ParkSense Warning Display is located in the Instrument cluster's EVIC display. It provides both visual and 10 mph (16 km/h). audible warnings to indicate the distance between the ParkSense Sensors rear fascia/bumper and the detected obstacle. The four ParkSense sensors, located in the rear fascia/ bumper, monitor the area behind the vehicle that is within the sensors' field of view. The sensors can detect obstacles from approximately 12 in (30 cm) up to 79 in (200 cm) from the rear fascia/bumper in the horizontal direction, depending on the location, type and orientation of the obstacle.