2010 Jeep Liberty Owner's Manual - Page 321

320 STARTING AND OPERATING engine either OFF or RUNNING. This shift cannot be Shifting can be performed with the vehicle rolling 2 to completed if the ignition switch is in the ACC position. 3 mph (3 to 5 km/h) using the "Preferred Procedure" or completely stopped using the "Alternate Procedure." NOTE: The four-wheel drive system will not allow shifts between 2WD and 4WD LOCK if the rear wheels Preferred Procedure are spinning (no traction). In this situation, the selected 1. With the engine RUNNING, slow the vehicle speed to position indicator light will flash and the original posi2 to 3 mph (3 to 5 km/h). tion indicator light will remain ON. At this time, reduce speed and stop spinning the wheels to complete the shift. 2. Shift the transmission into NEUTRAL. There may be a delay up to 10 seconds for the shift to 3. While still rolling, move the transfer case switch to the complete after the wheels have stopped spinning. desired position. Delayed shifting out of 4WD LOCK may be experienced 4. After the desired position indicator light is ON (not due to uneven tire wear, low tire pressure, or excessive flashing), shift the transmission into gear. loading. Alternate Procedure 4WD Lock to 4WD Low When shifting into or out of 4WD LOW, some gear noise 1. Bring the vehicle to a complete stop. may be heard. This noise is normal and is not detrimental to the vehicle or its occupants.