2010 Jeep Liberty Owner's Manual - Page 407

406 STARTING AND OPERATING The parking brake must be firmly engaged and the wheels chocked during driveshaft removal and installation. The parking brake must remain engaged unless the vehicle is securely and properly connected to the tow vehicle, or the driveshaft is completely reinstalled. See your authorized dealer for proper driveshaft removal and reinstallation procedures, including flange orientation/alignment, use of thread-locking compound, proper bolt torque specifications, etc. Four-Wheel Drive Models The transfer case must be shifted into NEUTRAL and the transmission must be placed in PARK for recreational towing. The NEUTRAL selection button is located at the top of the transfer case switch. Shifts into and out of transfer case NEUTRAL can take place with the selector switch in any mode position. CAUTION! • The transmission must be in PARK position for recreational towing. Failure to follow these procedures can cause severe transmission and/or transfer case damage. • Internal damage to the transmission or transfer case will occur if a front or rear wheel lift is used when recreational towing. • Before recreational towing, perform the procedure outlined under "Shifting into NEUTRAL" to be certain that the transfer case is fully in NEUTRAL. Otherwise, internal damage will result. • Do not use a bumper mounted clamp-on tow bar on your vehicle. The bumper face bar will be damaged.