2010 Jeep Liberty Owner's Manual - Page 54

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 53 3. Within 60 seconds of turning the ignition switch to the BeltAlert Programming BeltAlert can be enabled or disabled by your authorized ON position, unbuckle and then re-buckle the driver's dealer or by performing the following steps: seat belt at least three times within 10 seconds, ending with the seat belt buckled. NOTE: Chrysler Group LLC does not recommend deactivating BeltAlert . NOTE: Watch for the Seat Belt Reminder Light to turn on while unbuckling the seat belt and turn off while 1. With all doors closed, and the ignition switch in any re-buckling the seat belt. It may be necessary to retract position except ON or START, buckle the driver's seat the seat belt. belt. 4. Turn the ignition switch to the LOCK position. A 2. Turn the ignition switch to the ON position, but do not single chime will sound to signify that you have successstart the engine. Wait for the Seat Belt Reminder Light to fully completed the programming. turn off and then proceed to the next step. BeltAlert can be reactivated by repeating this procedure. NOTE: You must perform the following steps within 60 seconds of turning the ignition switch to the ON NOTE: When BeltAlert is deactivated, the Seat Belt position. Reminder Light will continue to illuminate as long as the driver's seat belt is unbuckled. 2