2010 Jeep Liberty Owner's Manual - Page 180
2010 Jeep Liberty Manual
Page 180 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 179 Gate Operator/Canadian Programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. It may be helpful to unplug the device during the cycling process to prevent possible overheating of the garage door or gate motor. If you unplugged the device for training, plug it back in at this time. Then proceed with Step 4 under "Programming HomeLink " earlier in this section. Using HomeLink To operate, press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, Security system, entry door lock, home/office lighting, etc.,). The handheld transmitter of the device may also be If you are having difficulties programming a garage door used at any time. opener or a gate operator, replace "Programming Reprogramming A Single HomeLink Button HomeLink " Step 3 with the following: 3. Continue to press and hold the HomeLink button, To reprogram a channel that has been previously trained, while you press and release ("cycle"), your handheld follow these steps: transmitter every two seconds until HomeLink has 1. Turn the ignition switch to the ON/RUN position. successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. 3