2010 Jeep Liberty Owner's Manual - Page 221
2010 Jeep Liberty Manual
Page 221 highlights
220 UNDERSTANDING YOUR INSTRUMENT PANEL torque split of 42% front axle and 58% rear axle. It can the repair/service, so that you can be sure that it is redirect up to 100% of torque to the front or rear axle, if properly reset, or that the door jamb sticker is accurate if the odometer must be reset at zero. necessary. 27. Odometer/Trip Odometer The odometer shows the total distance the vehicle has been driven. The trip odometer shows individual trip mileage. Refer to "Trip Odometer button" for additional information. NOTE: U.S. Federal regulations require that upon transfer of vehicle ownership, the seller certify to the purchaser the correct mileage that the vehicle has been driven. If your odometer needs to be repaired or serviced, the repair technician should leave the odometer reading the same as it was before the repair or service. If s/he cannot do so, then the odometer must be set at zero, and a sticker must be placed in the door jamb stating what the mileage was before the repair or service. It is a good idea for you to make a record of the odometer reading before Vehicle Odometer Messages When the appropriate conditions exist, the following messages will display in the odometer: ECO ...Fuel Saver Indicator Off ECO-ON ...Fuel Saver Indicator On door ...Door Ajar gATE ...Liftgate Ajar gLASS ...Flipper Glass Ajar LoW tirE...Low Tire Pressure gASCAP ...Fuel Cap Fault noFUSE ...Fuse Fault CHAngE OIL ...Oil Change Required On vehicles equipped with a Premium Instrument Cluster, this display shows the Electronic Vehicle Information