2010 Jeep Liberty Owner's Manual - Page 164

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 163 WARNING! Leaving the Electronic Speed Control system on when not in use is dangerous. You could accidentally set the system or cause it to go faster than you want. You could lose control and have an accident. Always leave the Electronic Speed Control system off when you are not using it. To Deactivate A soft tap on the brake pedal, or pulling the Electronic Speed Control lever toward you (cancel), or normal brake or clutch pressure while slowing the vehicle will deactivate the speed control without erasing the set speed from memory. Pressing the ON/OFF button or turning off the ignition erases the set speed from memory. 3 NOTE: For vehicles equipped with a manual transmission, pressing the clutch pedal will disengage the speed To Set a Desired Speed control. A slight increase in engine RPM before the When the vehicle reaches the speed desired, press down Electronic Speed Control disengages is normal. on the SET DECEL lever and release. Release the accelerator and the vehicle will operate at the selected speed. To Resume Speed If you deactivated the Electronic Speed Control without NOTE: erasing the set speed from memory and your vehicle • The vehicle must be traveling at least 25 mph speed is above 20 mph (32 km/h) you can resume the (40 km/h) for the Electronic Speed Control to set. previous set speed. To do so, push the lever up and • The vehicle should be traveling at a steady speed and release (RESUME ACCEL), and then remove your foot on level ground before pressing the SET DECEL lever. from the accelerator pedal.