2010 Jeep Liberty Owner's Manual - Page 410

STARTING AND OPERATING 409 3. Turn the ignition switch to the ON position, but do not start the engine. NOTE: Steps 1 through 6 are requirements for shifting the transfer case. If these requirements are not met prior to depressing the NEUTRAL selection button or while 4. Press the brake pedal. the shift attempt is in process, then all of the mode 5. Shift the transmission into NEUTRAL. position indicator lights will flash continuously until all requirements are met or until the NEUTRAL button is 6. Use the point of a ballpoint pen or similar object to released. press the recessed transfer case NEUTRAL button. Release the NEUTRAL button after the NEUTRAL indicator The ignition switch must be in the ON position for a shift light turns off (approximately one second). After the to take place and for the position indicator lights to be NEUTRAL button is released, the transfer case will shift operable. If the ignition switch in not in the ON position, to the position identified by the selector switch. the shift will not take place and no position indicator lights will be on or flashing. 7. Start the engine. Flashing NEUTRAL position indicator light indicates 8. Shift the transmission into DRIVE. that shift requirements have not been met. 9. Set the parking brake. 10. Shift the transmission into PARK. 5