2010 Jeep Liberty Owner's Manual - Page 322
2010 Jeep Liberty Manual
Page 322 highlights
STARTING AND OPERATING 321 2. With the ignition switch in the ON position, and the operable. If the ignition switch is not in the ON position, engine OFF or RUNNING, shift the transmission into then the shift will not take place and no position indicator lights will be on or flashing. NEUTRAL. 3. Move the transfer case switch to the desired position. MP3022 Selec-Trac II Transfer Case - If Equipped 4. After the desired position indicator light is on (not Operating Information and Precautions flashing), shift the transmission into gear. The Selec-Trac II active on-demand transfer case proNOTE: Steps 1 and 2 in the "Preferred Procedure" and vides four positions: the "Alternate Procedure" are requirements for shifting the transfer case. If these requirements are not met prior • Two-wheel drive (2WD) high range to attempting the shift or while the shift attempt is in • Four-wheel drive Auto (4WD AUTO) high range process, then the indicator light will flash, and the current transfer case position will be maintained. To retry • Neutral (N) a shift, move the transfer case switch back to the original • Four-wheel drive (4WD) low range position, make certain all shift requirements have been This transfer case is intended to be driven in either the met, wait five seconds, and try the shift again. two-wheel drive position (2WD) or the four-wheel drive The ignition switch must be in the ON position for a shift Auto position (4WD AUTO) for normal street and highto take place and for the position indicator lights to be way conditions such as dry hard-surfaced roads. 5