2010 Jeep Liberty Owner's Manual - Page 327

326 STARTING AND OPERATING vehicle stopped or in motion. If the vehicle is stopped, 3. While still rolling, move the transfer case switch to the the ignition switch must be in the ON position with the desired position. engine either OFF or RUNNING. This shift cannot be 4. After the desired position indicator light is on (not completed if the ignition switch is in the ACC position. flashing), shift the transmission into gear. 2WD or 4WD Auto to 4WD Low Alternate Procedure When shifting into or out of 4WD LOW, some gear noise may be heard. This noise is normal and is not detrimental 1. Bring the vehicle to a complete stop. to the vehicle or its occupants. 2. With the ignition switch in the ON position and the Shifting can be performed with the vehicle rolling 2 to engine OFF or RUNNING, shift the transmission into 3 mph (3 to 5 km/h) using the "Preferred Procedure" or NEUTRAL. completely stopped using the "Alternate Procedure." 3. Move the transfer case switch to the desired position. Preferred Procedure 4. After the desired position indicator light is on (not 1. With the engine RUNNING, slow the vehicle speed to flashing), shift the transmission into gear. 2 to 3 mph (3 to 5 km/h). NOTE: Steps 1 and 2 in the "Preferred Procedure" and 2. Shift the transmission into NEUTRAL. the "Alternate Procedure" are requirements for shifting the transfer case. If these requirements are not met prior to attempting the shift or while the shift attempt is in