2010 Jeep Liberty Owner's Manual - Page 217
2010 Jeep Liberty Manual
Page 217 highlights
216 UNDERSTANDING YOUR INSTRUMENT PANEL (48 km/h). If these conditions are not met while attempt- 20. Electronic Stability Program (ESP) / Brake Assist ing to use the HDC feature, the HDC indicator light will System (BAS) Indicator Light - If Equipped The malfunction indicator for the Electronic flash on/off. Stability Program (ESP) is combined with the 18. TOW/HAUL Indicator - If Equipped Brake Assist System (BAS). The yellow "ESP/ This light will illuminate when selecting BAS Warning Light" in the instrument cluster TOW/HAUL. The TOW/HAUL button is locomes on when the ignition switch is turned to the ON cated on the gearshift bezel. position. It should go out with the engine running. If the "ESP/BAS Warning Light" comes on continuously with 19. 4WD Indicator - Vehicles Equipped with the engine running, a malfunction has been detected in Command-Trac either the ESP or the BAS system, or both. If this light This light alerts the driver that the vehicle is in remains on after the several ignition cycles, and the the four-wheel drive mode. In this mode, the vehicle has been driven several miles/kilometers at front driveshaft and rear driveshaft are mespeeds greater than 30 mph (48 km/h), see an authorized chanically locked together forcing the front and dealer as soon as possible to have the problem diagnosed rear wheels to rotate at the same speed. and corrected. NOTE: The ESP Control System will make buzzing or clicking sounds when it is active. This is normal; the