2010 Jeep Liberty Owner's Manual - Page 220

UNDERSTANDING YOUR INSTRUMENT PANEL 219 CAUTION! Continuous driving with the Transmission Temperature Warning Light illuminated will eventually cause severe transmission damage or transmission failure. WARNING! In some circumstances a Transmission Temperature Warning Light, under continued operation, could cause the fluid to boil over, come in contact with hot engine or exhaust components and cause a fire. 25. Odometer / Trip Odometer / ECO (Fuel Saver Indicator) Button odometer mode. On vehicles equipped with a Base Cluster, press and release it once again to display the outside temperature. On vehicles equipped with a Mid Line Cluster, press and release it once again to display the outside temperature and compass heading in the screen below the speedometer. Refer to "Electronic Vehicle Information Center (EVIC) - If Equipped" for details. Resetting the Trip Odometer Display the trip mileage that you want to reset, "Trip A" or "Trip B." Then push and hold the button (approximately two seconds) until the display resets to 0. The odometer must be in Trip Mode to reset the trip odometer. 4 26. 4WD Indicator - Vehicles Equipped with Selec-Trac II Changing the Display This light alerts the driver that the vehicle is in Press this button to change the display from odometer to the full-time four-wheel drive auto mode. In either of the two trip odometer settings or the "ECO" this mode, the system operates with a normal display. Trip A or Trip B will appear when in the trip