2010 Jeep Liberty Owner's Manual - Page 172

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 171 If "SERVICE PARK ASSIST SYSTEM" appears in the Electronic Vehicle Information Center (EVIC) after making sure the rear fascia/bumper is clean and clear of The ParkSense switch LED will be ON when Park- snow, ice, mud, dirt or other obstruction, see your Sense is disabled or defective. The ParkSense switch authorized dealer. LED will be OFF when the system is enabled. The ParkSense system uses four sensors located in the Service the ParkSense Rear Park Assist System rear bumper fascia to scan for obstacles up to 79 in When the ParkSense Rear Park Assist System is mal- (200 cm) away from the rear bumper fascia. The warning functioning, the instrument cluster will actuate a single display located above in the Instrument Cluster's EVIC chime, once per ignition cycle, and it will display the provides both visible and audible warnings to indicate "SERVICE PARK ASSIST SYSTEM" message. Refer to the range of the object. When the ParkSense switch is pressed to disable the system, the instrument cluster will display the "PARK ASSIST DISABLED" message for approximately five seconds. Refer to "Electronic Vehicle Information Center (EVIC)" in "Understanding Your Instrument Panel" for further information. When the shift lever is moved to REVERSE and the system is disabled, the EVIC will display the "PARK ASSIST DISABLED" message for as long as the vehicle is in REVERSE. "Electronic Vehicle Information Center (EVIC)" in "Understanding Your Instrument Panel" for further information. When the shift lever is moved to REVERSE and the system has detected a faulted condition, the EVIC will display the "SERVICE PARK ASSIST SYSTEM" message for as long as the vehicle is in REVERSE. Under this condition ParkSense will not operate. 3