2010 Jeep Liberty Owner's Manual - Page 87

86 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE If you are required to drive with the trunk/liftgate open, Safety Checks You Should Make Inside the make sure that all windows are closed and the climate Vehicle control BLOWER switch is set at high speed. DO NOT Seat Belts use the recirculation mode. Inspect the belt system periodically, checking for cuts, The best protection against carbon monoxide entry into frays, and loose parts. Damaged parts must be replaced the vehicle body is a properly maintained engine exhaust immediately. Do not disassemble or modify the system. system. Front seat belt assemblies must be replaced after a Whenever a change is noticed in the sound of the exhaust collision. Rear seat belt assemblies must be replaced after system, when exhaust fumes can be detected inside the a collision if they have been damaged (i.e., bent retractor, vehicle, or when the underside or rear of the vehicle is torn webbing, etc.). If there is any question regarding belt damaged, have a competent mechanic inspect the com- or retractor condition, replace the belt. plete exhaust system and adjacent body areas for broken, Airbag Warning Light damaged, deteriorated, or mispositioned parts. Open The light should come on and remain on for six to eight seams or loose connections could permit exhaust fumes seconds as a bulb check when the ignition switch is first to seep into the passenger compartment. In addition, turned ON. If the light is not lit during starting, see your inspect the exhaust system each time the vehicle is raised authorized dealer. If the light stays on, flickers, or comes for lubrication or oil change. Replace as required. on while driving, have the system checked by an authorized dealer.