2010 Jeep Liberty Owner's Manual - Page 345

344 STARTING AND OPERATING Disabling and Enabling HSA This feature can be turned on or turned off. To change the current setting, proceed as follows: For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to "Hill Start Assist," under Personal Settings (Customer Programmable Features)," under "Electronic Vehicle Information Center (EVIC)" in "Understanding Your Instrument Panel" for further information. 3. Apply the parking brake. 4. Start the engine. 5. Rotate the steering wheel one-half turn to the left. 6. Press the ESP OFF button located in the lower switch bank below the climate control four times within twenty seconds. The "ESP/TCS Indicator Light" should turn on and turn off two times. 7. Rotate the steering wheel back to center and then an For vehicles not equipped with the EVIC, perform the additional one-half turn to the right. following steps: 8. Turn the ignition switch to the OFF position and then NOTE: You must complete Steps 1 through 8 within back to the ON position. If the sequence was completed 90 seconds. properly, the "ESP/TCS Indicator Light" will blink several times to confirm HSA is disabled. 1. Center the steering wheel (front wheels pointing straight forward). 9. Repeat these steps if you want to return this feature to its previous setting. 2. Shift the transmission into PARK.